Cleveland-motion-controls ULTRA SERIES UNDER PILLOW BLOCK TRANSDUCER UPB1 RE Uživatelský manuál Strana 8

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 18
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 7
ULTRA SERIES UNDER PILLOW BLOCK TRANSDUCER MAN-70254 REV. AA
PAGE 8 OF 18
2 SPECIFICATIONS
Item: Specification:
Transducer Weight
UPB1 UPB2
1.5 lbs.
0.68 kg.
12 lb.
5.4 kg
Mounting Plate with screws
UPB1 UPB2
2.2 lbs.
1 kg.
10 lb.
5 kg
Material
Strain Sensing beam – UPB1: 6061Aluminum
UPB2: 410 Stainless steel
Mounting Plate – 304 Stainless steel
Finish Material UPB1 only: Anodized Aluminum
Mounting Surface Flatness 0.002 inches from one side of transducer to the other.
Bridge Resistance
Steel Transducer: 135-147 Ohms @ 20
o
C
Aluminum Transducer: 122-134 Ohms @ 20
o
Gage Type Semi-conductor strain gage, gage factor equals 95 (nominal)
Connector Type M12 Quick-disconnect, 4 conductor, DC keyed
Excitation Voltage 5.6 VDC or VAC (RMS) maximum
(Excess voltage can cause permanent damage)
Nominal Output Signal at Rated
MWF
+/- 120 mV per Transducer (with 5.0 VDC or VAC rms excitation
voltage)
Output Impedance Steel Transducer: Approximately 64 Ohms per Bridge leg
Aluminum Transducer: Approximately 60 Ohms per Bridge leg
Ultimate Overload 500% MWF (typ) for units rated 10,000 M.W.F or less
250% MWF (typ) for units rated at 20,000 M.W.F or more
Maximum Voltage, Gage to
Beam or Base (Ground)
50 Volts peak
Operating Temperature Range 0
o
F to +200
o
F
Zobrazit stránku 7
1 2 3 4 5 6 7 8 9 10 11 12 13 ... 17 18

Komentáře k této Příručce

Žádné komentáře